How To Guide For General Finishes Water Based Stains

General Finishes Water Based Wood Stains are formulated to provide workability similar to oil-based stains. They spread easily, can be repaired, blend effortlessly and have plenty of open time. The thicker formula of these wood stains allow for controlled penetration and their high-quality pigments produce rich and dark, uniform colours on hard-to-stain woods like maple and pine. Low odor, low VOC, water cleanup and noncombustible.

 

Hand-Application over Raw Wood:

    • Apply a LIBERAL amount of stain to ensure easy workability using a synthetic bristle brush, foam brush, pad applicator or roller. (see links on pics for more info)>
    • If there's not enough stain used, the surface may dry too quickly, causing an uneven appearance. On large projects, leave a wet edge between sections to prevent lap lines.
    • Stain a complete section and wipe off the excess evenly with the grain using quality paper towel, or absorbent cotton open weave cloth or terry cloth.
    • Check for missed spots and lap marks before moving to the next section. Do NOT use cotton t-shirts to wipe away stain because they will "push" the stain around and not absorb it.
    • Pull excess stain out of corners and details with a synthetic bristle brush.
    • Immediately correct lap marks by rewetting the entire working area with stain and wiping off the excess.
    • Let the stain dry 2+ hours in ideal conditions: 50-70% humidity, 70*F/20*C before adding a second coat (optional) and before adding topcoat. Be sure to allow adequate dry time. If in doubt, wait longer. Increase dry time if: 
      • Humidity is over 80%
      • 3+ coats are applied (not recommended)
      • Thick coats are applied
      • To accelerate dry time in humid conditions, add General Finishes Accelerator before applying and work in a space with good ventilation and air movement. If you decide to re-coat before the recommended time, test dryness. 
APPLICATION
Coats 1+ coats
Application Method Brush, Spray
Brushable Yes
Usable over existing finishes Yes - see product page application instructions.
Sprayable Yes
Spray Tip Sizes HVLP 1.1mm-1.3mm
DRY TIME
Dry Time - Touch Raw Wood (30+ min.), Existing Finish (1+ hr)
Dry Time - Recoat 2+ hr
CONTENTS
Can Sizes Pints, Quarts, Gallons
Coverage 50-75 sq.ft./pint, 100-150 sq.ft./quart, 400-600 sq.ft./gallon

 

x